How to install Grizzly 400 Lid Prop
So to get started, you will just need the G400 Lid Prop kit. You can also use/download the following G400 Lid Prop Installation PDF Guide.
Total Time Needed: 30 minutes
Required Tools:
- 5/32 Allen Wrench. - 7/16 Wrench or Socket. - Flat Screw Driver.Things Needed?
- G400 Lid Prop Kit.Steps to configure the How-to Schema widget:
Step 1 : Remove Plugs Using a flat head screwdriver, remove the two plugs in the top of the G400 cooler lid.
Step 2 : Remove Bolt
Using a 7⁄16 wrench or socket and ⁵⁄₃₂ Allen wrench, remove the
bolt between the two pieces.
Step 3 : Remove Top Piece
Remove the two nuts holding the top portion to the lid, remove top piece.
Step 4 : Remove Bottom Piece
Remove the outer nut on bottom piece, remove bottom piece.
Step 5: Remove Secondary Nut
Remove secondary nut.
Step 6: Install Bottom Bolt
Reinstall new bottom bolt with washer on
inside of cooler. Add inner nut and tighten.
Step7: Add Washer
Add second washer to inner bottom bolt.
Step 8: Install Bottom Bracket
Place bottom bracket onto bottom bolt. Add another washer to outside of bottom bracket. Add nut and tighten bolt so one thread is exposed - do not over-tighten, need some free play.
Step 9: Install Top Bracket
Install top bracket, tighten upper bracket bolts.
Step 10: Install Lid Prop
Place bolt through top bracket, then a washer. Slide bottom bracket into place, no additional washer is needed. Add nut, tighten bolt, leaving a little free play.
Step 11: Replace Plugs
Replace finish plugs so they are flush with the top of the Grizzly 400 cooler lid.
